Safe, efficient, reliable, and continue to create value

Follow the official WeChat
News

News

Current position: News > Download
nvepak Strapping Tool

Scan the QR code to provide professional packaging solutions and quotationsScan the QR code to provide professional packaging solutions and quotations

+86 13647419800

B19 Portable Pneumatic Baler Operating Instructions

Release time: 2021-05-28 10:38:19

B19 portable pneumatic baler operating steps

       1. Packaging products
           As shown in the picture, tie the package with packing tape, hold the overlapping part with your left hand, leave about 300mm of the tail, and gently pull out the remaining part with your right hand.
       2. Install packing tape
           Hold the handle and tensioner with your right hand (the distance between the packaging tensioning wheel and the tensioning tooth plate is the largest), and insert the upper and lower parts of the packaging belt into the baler at the same time.
       3. Tighten the packing straps
           Press and hold the tightening button (right side) with your right thumb until the strap is fully taut.
       4. Vibration and cut-off
           Press and hold the welding button (red) with your right thumb until the strapping is welded and cut.
       5. Remove the baler
           Squeeze the handle and tensioner with your right hand. Use the little finger of your right hand to press the rewind button until the strap is loosened from the tensioning wheel. Squeeze the handle and tensioner and remove the tool from the strap.
       Note: Do not remove the baler without loosening the straps.

49
More>>

Product recommendations

Consult
Repair
Phone
+86 13647419800
Top