Neiwei Packaging customer service often receives calls for help from customers. Why does the pneumatic baler always break down after being used for a long time? It takes too long to return to the factory for repair, which delays the progress of the project. However, I do not know the technology and do not know how to do it myself. In fact, whether it is a pneumatic baler or other equipment used for a long time, failures are inevitable due to wear of various accessories or improper daily maintenance. However, not all faults need to be returned to the factory for repair. Today, Neiwei Packaging will provide you with an analysis of common faults of the pneumatic baler. When a minor fault occurs in the pneumatic baler in your hand, you can solve it in time by yourself, reducing repair time and cost to ensure packaging efficiency.

STB73

      Fault 1: The baling machine cuts the baling tape continuously
              This situation is mainly caused by serious wear of the cutter, stuck motor, and low air pressure. First check the wear degree of the cutter. If the wear is serious, replace it in time; at the same time, check whether the working pressure of the baler is normal; if If the motor is stuck, then you need to drip special motor lubricating oil into the pneumatic baler in time. Pay special attention to the maintenance of motor oiling.

      Fault 2: The tightening force of the baler is not strong
              The main reason for weak tightening force is that the air pressure of the air pump is unstable. If the air pressure is too small or unstable when the pneumatic baler is working, the tightening force will be small and the welding effect will be affected. Air pressure issues should be checked before operating the pneumatic baler. Another phenomenon will also occur if the tightening wheel slips. This situation is mostly caused by the wear of the teeth of the tightening wheel, which can be solved by replacing the tightening wheel in time.

      Fault 3: Poor welding effect
              If the tool holder and friction plate are severely worn, the strapping belt will be welded and not bonded, resulting in belt breakage. This situation can be solved by simply replacing the new tool holder and friction plate.
       The above three situations are fault problems that many pneumatic balers will encounter. Generally, the tool holder, friction plate, tool holder and other accessories can be used normally if the tool holder, friction plate, tool holder and other accessories are replaced in time. In addition, it is particularly important to do daily cleaning and maintenance of the baler. Neiwei Packaging also provides pneumatic baler maintenance services to the majority of users. If you need to know more specific conditions, you can click online consultation and our technical staff will serve you wholeheartedly.