The pneumatic baler mainly relies on an air pump to generate power. It not only has super strong pulling force, but is also affordable. It is the first choice machine for many small and medium-sized brick factories. However, compared with electric balers, due to the harsh environment of brick factories, many pneumatic balers have a common fatal point, which is a high failure rate. Many people call to inquire about how to maintain the pneumatic baler, reduce the failure rate of the equipment, and ensure the normal work progress of the brick factory. Today, Neiwei experts will share with you some daily care and maintenance methods for pneumatic balers.

Pneumatic baler

       1. The motor bearing of the pneumatic baler cannot be started.
            Pneumatic balers have relatively high requirements for air sources, but the working environment in brick factories is mostly high temperature, dusty, and humid. Therefore, the baler will inhale dust and moisture in the air during work. When the motor bearing fails to start, the editor recommends cleaning the water in the oil-water separator and air compressor tank every three to four days. If the packing frequency is too high, it can be drained every other day to ensure the dryness of the air source and avoid pneumatic damage. The inside of the baler is damp, rusty and dusty.

       2. The motor often gets stuck and cannot rotate.
            When the baler is used frequently, the motor will become unable to rotate. Therefore, lubricating oil should be maintained at the air inlet interface of the equipment every two or three days to lubricate the pneumatic motor and transmission device inside the baler. Secondly, regular lubrication can not only lubricate the internal parts of the equipment, but also discharge dust and debris remaining in the machine. Here, the editor specially reminds users that when lubricating the pneumatic baler, they must use lubricating oil specially designed for the baler, and do not use car lubricating oil at will.

Portable pneumatic baler

       3. The anti-sliding block and tightening wheel of the pneumatic baler are easy to wear
            The tightening wheel and the anti-sliding block of the pneumatic baler are embedded in each other without a belt. Many workers, due to lack of professional knowledge, empty the baling machine, which can easily cause wear of the anti-sliding block and the tightening wheel. Therefore, when there is no strapping or maintenance, remember to run the baler idling. If you need to run the baler idling to clean the dust debris in the tightening wheel, you must first tighten the body and lift it (such as the operation action of putting the strap in), and then press Press the tighten button.
        Knowing the above reasons, when a problem occurs with the pneumatic baler, the fault can be handled promptly and correctly, which can shorten the maintenance cycle to a certain extent and ensure the normal baling efficiency of the brick factory. If you encounter a fault that cannot be solved, you can call the Naiwei packaging hotline at any time: 13647419800. Our company has a professional maintenance team to help you solve your problems.